Published at Tuesday, July 30th 2019, 01:17:36 AM. Speaker Stands. By Edsel Zimmermann.
Moseco are the designer model in the Atacama range using both acoustic and environmentally friendly Bamboo to enhance the listening experience. Moseco has recently been awarded both 5 stars and BEST SPEAKER STANDS 2014, 2015, 2016, 2017 and 2018 in What Hi-Fi? S & V magazine ,so don’t just take our word for it!
It’s physics: for every action, there’s an equal and opposite reaction.
An isolation platform works in a similar way to a car’s suspension, and comprises three mechanical components: a spring, a mass supported by the spring, and some form of damping to prevent the sprung mass from continuing to bounce around. In a car you have the springs between the axles and the car body: the car body provides the mass and the shock absorbers provide the damping, to stop you having a bouncy ride.
Centre Channel speakers require dedicated stands as they tend to be of unconventional dimensions. The CC Series provides that solution and are available in a wide range of height options.
A cheap DIY option is to build a couple of towers by stacking concrete blocks or bricks. This low–cost approach really works — we’ve used it successfully on more than one Studio SOS visit — and because of the high mass, very little vibrational energy makes it through to the floor. Some people like the rugged appearance of bricks, but if it’s not to your taste you can always disguise them with cloth drapes, or even spray them gold if you like that kind of thing!
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.