Published at Monday, July 29th 2019, 02:17:16 AM. Speaker Stands. By Hardtman Fuchs.
If you already have a pair of simple foam speaker platforms, you can improve their performance simply by gluing a heavy floor tile to the top. Ordinary contact adhesive works fine for this. Then you can either glue some kitchen mat to the upper surface, to provide some grip, or use Blu–Tack, as discussed earlier, between the tile and the loudspeaker.
Thus, the sand provides dampening, but it also prevents the stand from ringing when it’s excited by the right frequencies – another handy little add-on.
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
A speaker platform is designed primarily to provide a degree of mechanical isolation between the speaker and the surface upon which it is placed, while keeping the speaker firmly in place. This is particularly important when siting speakers on lightweight desks or shelves, as these can easily be set into vibration if in direct contact with a speaker cabinet.
should also avoid putting them into enclosed spaces, such as under desks with side panels, as this creates a resonant system that can further mess with bass clarity and evenness. Also be aware that you need to maintain a minimum distance between the cabinet and walls when positioning both rear–ported subwoofers and speakers. Details of how far this needs to be should be included in your speaker or sub’s manual.
If you already have a speaker stand with spikes and your floor is made of wood, then you should consider putting some form of isolation platform between the speaker and the stand, to prevent the cabinet vibrations reaching the stand and, through it, the floor. Avoid flimsy stands that move or rock when you touch them. If the final assembly doesn’t feel completely solid, avoid it.
The theory is that the mass and spring characteristics are chosen so that the resonant frequency of the combination is well below that of any frequency they’re likely to be asked to isolate. For example, if the lowest note a speaker can reproduce is 30Hz, then the resonant frequency of the supporting platform needs to be well below that — perhaps just a few Hertz or less.