Published at Thursday, July 25th 2019, 02:16:47 AM. Speaker Stands. By Conradina Scholz.
The heavier the stand, the less it will move, and with many hi–fi and pro–audio speaker stands (including many of the models made by Atacama, for example), it’s possible to fill the hollow support column with a heavy material to add mass and to damp resonances. This could be sand, shot or any other heavy but well–damped material.
And according to Otto Jørgensen, this is where you have the most to gain from acquiring a pair of speaker stands: “The most impactful benefit of getting stands is added distance between your speakers and surfaces. It keeps early reflections to a minimum. And that’s especially important for the speakers’ low-end performance.”
A speaker platform is designed primarily to provide a degree of mechanical isolation between the speaker and the surface upon which it is placed, while keeping the speaker firmly in place. This is particularly important when siting speakers on lightweight desks or shelves, as these can easily be set into vibration if in direct contact with a speaker cabinet.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
Whether you use stands or platforms depends on what else you have in your system: usually you’ll pick whichever makes it easiest to get your speakers into the right physical position without them being occluded by other equipment, such as computer screens.
The range begins with the award winning Nexus Series, a three column design made for the HiFi enthusiast. As with all Atacama speaker stands, Nexus allows you to increase the mass of the stand by filling the largest column with Atabites.