By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:06:46 PM.
To sum up, the platforms with a heavy plate of some type on top are the most effective, though you can add mass very easily to any type of support by using floor tiles. Similarly, the more massive and better damped a speaker stand, the less vibrational energy is likely to make it through to the floor and less the stand itself will vibrate. Compared with the cost of speakers, adding suitable stands or platforms is relatively inexpensive, yet it can make a very worthwhile improvement to the overall sound quality!
The range begins with the award winning Nexus Series, a three column design made for the HiFi enthusiast. As with all Atacama speaker stands, Nexus allows you to increase the mass of the stand by filling the largest column with Atabites.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
Their smaller stands are made from a type of plastic and their larger ones from cast metal. All are perfectly valid approaches. Note that some speakers, such as certain Genelec models and Event’s Opals, already come with resilient isolating platforms or feet and so may not need additional treatment.
You can make a speaker move less in many different ways, and one of those is by adding more mass to the speaker and the stand; making it harder for the speaker to move. That’s why you’ll find a sand compartment in most stands.
And stands are especially helpful in the low-frequency area, as this part of the frequency spectrum is omnidirectional and therefore more sensitive to surfaces nearby than the high-frequency area.