Published at Wednesday, July 31st 2019, 07:41:33 AM. Speaker Stands. By Emestina Krause.
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
And stands are especially helpful in the low-frequency area, as this part of the frequency spectrum is omnidirectional and therefore more sensitive to surfaces nearby than the high-frequency area.
Atacama offer a wide range of speaker stands with a choice of colours, dimensions and style to satisfy most requirements .
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
There you have it; the basics of why you should consider stands for your bookshelf speakers. As with much in hi-fi, this is only the introduction to a massive subject, but it serves as a good understanding of stands function and what they can do for your hi-fi system. And they can do a lot for providing your speakers with the optimal condition for top-notch performance.
One of the roles of an effective speaker support is to prevent such vibrations from being transferred into other structures, such as wooden floors, desktops, shelves or mixer meterbridges. It should also hold the speaker as firmly as possible, to reduce movement due to the action/reaction effect.
If you visit the various hi–fi forums you’ll find a number of conflicting views on what the best material to use is, but there’s often little to back up people’s claims, and I’d suggest that that way lies madness! Dry playground sand works just fine, and you can even leave it inside plastic bags if you wish to avoid things getting messy.