By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:05:55 PM.
Furthermore, in accordance with Newton’s third law of motion (each action has an equal and opposite reaction), whenever the speaker cone moves in one direction it will try to push the speaker cabinet the other way.
The theory is that the mass and spring characteristics are chosen so that the resonant frequency of the combination is well below that of any frequency they’re likely to be asked to isolate. For example, if the lowest note a speaker can reproduce is 30Hz, then the resonant frequency of the supporting platform needs to be well below that — perhaps just a few Hertz or less.
To sum up, the platforms with a heavy plate of some type on top are the most effective, though you can add mass very easily to any type of support by using floor tiles. Similarly, the more massive and better damped a speaker stand, the less vibrational energy is likely to make it through to the floor and less the stand itself will vibrate. Compared with the cost of speakers, adding suitable stands or platforms is relatively inexpensive, yet it can make a very worthwhile improvement to the overall sound quality!
The HMS Series is considered to be Audiophile level by many and incorporates a significant increase in mass loading capacity and designed with very high quality speakers in mind such ProAc and other premium manufactures.
Their smaller stands are made from a type of plastic and their larger ones from cast metal. All are perfectly valid approaches. Note that some speakers, such as certain Genelec models and Event’s Opals, already come with resilient isolating platforms or feet and so may not need additional treatment.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.