By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:04:34 PM.
And, of course, it needs to put the speaker in the correct position relative to the listener, which usually means with the tweeter aimed at an imaginary point just behind the listener’s head. Note, though, that a few speakers are deliberately designed to be aimed directly ahead rather than at the listener, so always check the recommendations in the manual that comes with your particular loudspeaker before directing them inwards.
The theory is that the mass and spring characteristics are chosen so that the resonant frequency of the combination is well below that of any frequency they’re likely to be asked to isolate. For example, if the lowest note a speaker can reproduce is 30Hz, then the resonant frequency of the supporting platform needs to be well below that — perhaps just a few Hertz or less.
We might call them bookshelf speakers, but does that mean it’s a good idea to put them on one? Nothing is stopping you from doing it, but it’s your sound performance that’s at stake – and there’s much to lose – and, if you’ve just shelled out a significant amount for your new speakers, it’s a bad start to what should be a great investment.
To sum up, the platforms with a heavy plate of some type on top are the most effective, though you can add mass very easily to any type of support by using floor tiles. Similarly, the more massive and better damped a speaker stand, the less vibrational energy is likely to make it through to the floor and less the stand itself will vibrate. Compared with the cost of speakers, adding suitable stands or platforms is relatively inexpensive, yet it can make a very worthwhile improvement to the overall sound quality!
The SLX Series is a professional quality stand which caters for larger bookshelf speakers where an increase in the footprint is required to ensure optimum stability.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.