By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:06:51 PM.
And, of course, it needs to put the speaker in the correct position relative to the listener, which usually means with the tweeter aimed at an imaginary point just behind the listener’s head. Note, though, that a few speakers are deliberately designed to be aimed directly ahead rather than at the listener, so always check the recommendations in the manual that comes with your particular loudspeaker before directing them inwards.
You can make a speaker move less in many different ways, and one of those is by adding more mass to the speaker and the stand; making it harder for the speaker to move. That’s why you’ll find a sand compartment in most stands.
should also avoid putting them into enclosed spaces, such as under desks with side panels, as this creates a resonant system that can further mess with bass clarity and evenness. Also be aware that you need to maintain a minimum distance between the cabinet and walls when positioning both rear–ported subwoofers and speakers. Details of how far this needs to be should be included in your speaker or sub’s manual.
The HMS Series is considered to be Audiophile level by many and incorporates a significant increase in mass loading capacity and designed with very high quality speakers in mind such ProAc and other premium manufactures.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
You could just plonk your speaker onto the top of your chosen stand, of course, but it’s best to have the speaker fixed to the stand in some way, because otherwise it can slide around. One popular and effective method is to place blobs of Blu–Tack under each corner; this acts as both a removable adhesive and as a damping medium. Another alternative is to use high–friction rubber matting, of the type sold for workshops and kitchens.