By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:05:19 PM.
should also avoid putting them into enclosed spaces, such as under desks with side panels, as this creates a resonant system that can further mess with bass clarity and evenness. Also be aware that you need to maintain a minimum distance between the cabinet and walls when positioning both rear–ported subwoofers and speakers. Details of how far this needs to be should be included in your speaker or sub’s manual.
You could just plonk your speaker onto the top of your chosen stand, of course, but it’s best to have the speaker fixed to the stand in some way, because otherwise it can slide around. One popular and effective method is to place blobs of Blu–Tack under each corner; this acts as both a removable adhesive and as a damping medium. Another alternative is to use high–friction rubber matting, of the type sold for workshops and kitchens.
And, of course, it needs to put the speaker in the correct position relative to the listener, which usually means with the tweeter aimed at an imaginary point just behind the listener’s head. Note, though, that a few speakers are deliberately designed to be aimed directly ahead rather than at the listener, so always check the recommendations in the manual that comes with your particular loudspeaker before directing them inwards.
A cheap DIY option is to build a couple of towers by stacking concrete blocks or bricks. This low–cost approach really works — we’ve used it successfully on more than one Studio SOS visit — and because of the high mass, very little vibrational energy makes it through to the floor. Some people like the rugged appearance of bricks, but if it’s not to your taste you can always disguise them with cloth drapes, or even spray them gold if you like that kind of thing!
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.
One way to improve the situation is to add mass by means of a platform fixed to the top surface of the foam. Primacoustic do this in their Recoil Stabilizer by using a very thick steel slab with rubber matting on top, while Auralex and other companies use MDF topped with dense rubber on their more up–market platforms. IsoAcoustics take yet a different approach, by using a frame made from rigid components joined by resilient isolators.