By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:03:07 PM.
You could just plonk your speaker onto the top of your chosen stand, of course, but it’s best to have the speaker fixed to the stand in some way, because otherwise it can slide around. One popular and effective method is to place blobs of Blu–Tack under each corner; this acts as both a removable adhesive and as a damping medium. Another alternative is to use high–friction rubber matting, of the type sold for workshops and kitchens.
Furthermore, in accordance with Newton’s third law of motion (each action has an equal and opposite reaction), whenever the speaker cone moves in one direction it will try to push the speaker cabinet the other way.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
There you have it; the basics of why you should consider stands for your bookshelf speakers. As with much in hi-fi, this is only the introduction to a massive subject, but it serves as a good understanding of stands function and what they can do for your hi-fi system. And they can do a lot for providing your speakers with the optimal condition for top-notch performance.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.