By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:04:23 PM.
There you have it; the basics of why you should consider stands for your bookshelf speakers. As with much in hi-fi, this is only the introduction to a massive subject, but it serves as a good understanding of stands function and what they can do for your hi-fi system. And they can do a lot for providing your speakers with the optimal condition for top-notch performance.
Of course, you do still need to attend to room reflections by adding some basic acoustic treatment — but that’s another subject and one that we have covered on numerous occasions in our Studio SOS series.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
The heavier the stand, the less it will move, and with many hi–fi and pro–audio speaker stands (including many of the models made by Atacama, for example), it’s possible to fill the hollow support column with a heavy material to add mass and to damp resonances. This could be sand, shot or any other heavy but well–damped material.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.