By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:03:23 PM.
Many stands come with a compartment dedicated to sand and similarly heavy and well-damped materials. And there’s method in the madness. You see, the speaker plays music by moving its drive unit in and out to create sound pressure: when the drive unit pushes outwards, it creates sound pressure, but when it moves inwards it pushes the entire speaker backwards.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.
To sum up, the platforms with a heavy plate of some type on top are the most effective, though you can add mass very easily to any type of support by using floor tiles. Similarly, the more massive and better damped a speaker stand, the less vibrational energy is likely to make it through to the floor and less the stand itself will vibrate. Compared with the cost of speakers, adding suitable stands or platforms is relatively inexpensive, yet it can make a very worthwhile improvement to the overall sound quality!
One way to improve the situation is to add mass by means of a platform fixed to the top surface of the foam. Primacoustic do this in their Recoil Stabilizer by using a very thick steel slab with rubber matting on top, while Auralex and other companies use MDF topped with dense rubber on their more up–market platforms. IsoAcoustics take yet a different approach, by using a frame made from rigid components joined by resilient isolators.
Furthermore, in accordance with Newton’s third law of motion (each action has an equal and opposite reaction), whenever the speaker cone moves in one direction it will try to push the speaker cabinet the other way.