By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:02:54 PM.
If the output from the sub seems uneven, you need to try and find a location where it produces a less lumpy response. A good tip for doing this is to temporarily place the sub where you normally sit to mix, and then listen at different places around the edges of the room while playing back a same level chromatic (semitone) scale of sine waves from a sampler until you find the spot that produce the most consistent level across all notes.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.
Even if you already have a loudspeaker stand, you can still use one of these foam–based speaker platforms on top of it to reduce the amount of vibration getting into the stand and subsequently into the floor. Many of the commercially available platforms come with additional foam wedges that may be used to adjust the vertical angle of the speaker if necessary.
Subwoofers can be placed directly onto solid floors, but an isolation platform of some type will help clean up the sound if that floor is made of wood or chipboard. It isn’t a good idea to position subs very far from the floor — up to about 150mm shouldn’t present a problem, but more than that and the reflections can start to cause issues.
If you already have a pair of simple foam speaker platforms, you can improve their performance simply by gluing a heavy floor tile to the top. Ordinary contact adhesive works fine for this. Then you can either glue some kitchen mat to the upper surface, to provide some grip, or use Blu–Tack, as discussed earlier, between the tile and the loudspeaker.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.