By Wilde Becker. Speaker Stands. At Tuesday, July 30th 2019, 19:11:33 PM.
To sum up, the platforms with a heavy plate of some type on top are the most effective, though you can add mass very easily to any type of support by using floor tiles. Similarly, the more massive and better damped a speaker stand, the less vibrational energy is likely to make it through to the floor and less the stand itself will vibrate. Compared with the cost of speakers, adding suitable stands or platforms is relatively inexpensive, yet it can make a very worthwhile improvement to the overall sound quality!
Fortunately, we don’t need to balance the speaker on actual springs, as a suitably dense piece of acoustic foam can act as both spring and damper. The speaker cabinet provides mass — so sitting a speaker cabinet directly onto a piece of foam, such as an Auralex MoPad, will bring about an improvement in the amount of vibrational energy getting through to the desk. However, foam isn’t particularly rigid, so the cabinet may still tend to move back and forth slightly as the speaker cones move, especially if the speaker cabinet isn’t particularly heavy.
Whether you use stands or platforms depends on what else you have in your system: usually you’ll pick whichever makes it easiest to get your speakers into the right physical position without them being occluded by other equipment, such as computer screens.
Speaker positioning is critical when it comes to creating the ideal soundscape. KEF Performance Speaker Stands were engineered in the UK specifically to ensure bookshelf speakers sound at their best. This encompasses ideal driver height positioning, steel damping plates accompanied by aluminium tube and base plates, and space available for the addition of inert filler for further stability. The Performance Speaker Stand is ideal for the LS50 and LS50 Wireless, but can also be utilised by other KEF Bookshelf Speakers.
The theory is that the mass and spring characteristics are chosen so that the resonant frequency of the combination is well below that of any frequency they’re likely to be asked to isolate. For example, if the lowest note a speaker can reproduce is 30Hz, then the resonant frequency of the supporting platform needs to be well below that — perhaps just a few Hertz or less.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.