Published at Wednesday, July 31st 2019, 07:41:25 AM. Speaker Stands. By Adalwine Huber.
It’s physics: for every action, there’s an equal and opposite reaction.
Subwoofers can be placed directly onto solid floors, but an isolation platform of some type will help clean up the sound if that floor is made of wood or chipboard. It isn’t a good idea to position subs very far from the floor — up to about 150mm shouldn’t present a problem, but more than that and the reflections can start to cause issues.
That’s where you need to put the sub. If your sub has a phase adjustment knob, or a polarity–invert switch, adjust this until you hear the loudest result from frequencies around the crossover point, typically 80 to 120 Hz.
Their smaller stands are made from a type of plastic and their larger ones from cast metal. All are perfectly valid approaches. Note that some speakers, such as certain Genelec models and Event’s Opals, already come with resilient isolating platforms or feet and so may not need additional treatment.
Where vibrations are allowed to leak into any studio furniture or wooden floors, the audible result is often a blurring of the bass and lower mid range, as well as a deterioration in the stereo image. By using an appropriate stand or platform, the bass end should tighten up to a very noticeable degree, leaving the mids sounding clearer and the imaging better defined.
The heavier the stand, the less it will move, and with many hi–fi and pro–audio speaker stands (including many of the models made by Atacama, for example), it’s possible to fill the hollow support column with a heavy material to add mass and to damp resonances. This could be sand, shot or any other heavy but well–damped material.
Even if you already have a loudspeaker stand, you can still use one of these foam–based speaker platforms on top of it to reduce the amount of vibration getting into the stand and subsequently into the floor. Many of the commercially available platforms come with additional foam wedges that may be used to adjust the vertical angle of the speaker if necessary.